Table of Contents
Advertisement
5.
Mix epoxy in mixing cup and use a tapered
stick to apply the epoxy inside the pre-drilled
holes in the trailing edge of the fin.
6. Carefully slide each hinge into the trailing edge
of the vertical fin. Wipe away excess epoxy with
alcohol wetted wipes.
7. Ensure there is minimal to no gap between fin
and rudder. Allow epoxy to fully cure.
Note: Ensure you have full rudder deflection
before epoxy fully cures.
Rudder Servo Installation
1. Gather the rudder control linkage parts shown
below.
Required Parts
◊
2 - 3" Double Output Servo Arms
◊
2 - Pushrod Couplers
◊
4 - 4-40 ball link assemblies
◊
2 - 4-40x16mm Bolts
◊
2 - 4-40x20mm Bolts
◊
4 - 4-40 Lock Nuts
◊
2 - Brass spacers (Not Pictured)
◊
4 - Flat washer
Required Parts -Not Included
◊
2 - Rudder servos
◊
8 - Servo Mounting Screws (Micro Fastener
Part number STW0209 recommended)
◊
2 - 3" servo arms
◊
2 - Safety clips
◊
1 - Heavy Duty Y Harness (Optional)
Required Tools and Adhesives
◊
1 - 5/64" Ball Driver
◊
1 - 3/32" Ball Driver
◊
1 - Pushrod Adjustment Wrench (Supplied)
◊
1 - Electric Drill
◊
1 - 1/16" Drill Bit
28
Hide quick links:
Advertisement
Table of Contents
