Table of Contents
Advertisement
5.
Mix epoxy in mixing cup and use a tapered
stick to apply the epoxy inside the pre-drilled
holes in the leading edge of the rudder. Apply
epoxy onto each hinge.
6.
Carefully slide the rudder onto each hinge and
against the trailing edge of the fin. Wipe away
excess epoxy with alcohol wetted wipes.
7.
Ensure there is minimal to no gap between fin
and rudder. Allow epoxy to fully cure.
Note: Ensure you have full rudder deflection
before epoxy fully cures.
Rudder Servos Installation
1. Gather the rudder servos (min 180 in./oz.) and a
11" Y harness as shown below.
Note: If using higher Torque (min 300 in./oz.)
Digital, Metal geared servo, only two servos
are required. This is the installation we will
use. If three servos are used, installation
process will be similar.
29
Hide quick links:
Advertisement
Table of Contents
