Mechanical Scrubbing System: What To Do If - Fimap IMx Workshop Manual

3.3

Mechanical scrubbing system: what to do if. . .

1) The machine is switched off
2) The machine doesn't switch on
3) (Only B-BT) The display shows an
alarm message
4) (Only B-BT) The switch "Auto" is
not pressed
5) The dead man switch doesn't work
6) The brush deck motor is not sup-
plied
7) The brush rotates in opposite way
8) The brushdeck is lifted from the
floor
9) The brush is not properly engaged
10) The solution flow rate is not correct
or not enough
The machine doesn't clean well
Switch on the machine.
Refer to the proper section
.
3.1 at page 8)
Refer to the proper section
.
3.1 at page 8)
Press the "Auto" switch.
Replace the dead man switch
.
tion 4.1.14 at page 21)
Verify the motor connections.
Check the motor connections.
Tilt down the machine to let the
brush touch the floor.
Release and engage properly the
brush.
Refer to the proper section.
3-17
(see section
(see section
(see sec-