Reboot - Digi TransPort User Manual

Related CLI commands
The router's configuration can be reset back to the factory defaults using the following
commands:
del pwds.da0
copy config.fac config.da0
This assumes that you are using configuration profile 0. If configuration profile 1 is being used,
then the .da1 suffix should be used instead of .da0.
Please note that using these commands does not preserve any network settings.
Reset using the hardware Reset button
There is a reset button on the underside of most routers, holding this button in for 5 seconds will
perform a factory reset on the router. When the reset is initiated in this manner, the LEDs on the
front of the router will flash to indicate a reset is in progress, the router will automatically reboot
once the procedure is complete. Do not remove the power whilst the router is running this reset
procedure. Using this method will not preserve any settings.
The CLI command to disable the reset button is
cmd 0 pbreset off.
To re-enable the reset button functionality
.
cmd 0 pbreset on
Digi TransPort User Guide 521