Digi TransPort User Manual page 162

Entity
ppp
ppp
ppp
ppp
ppp
ppp
ppp
ppp
ppp
ppp
ppp
ppp
ppp
ppp
Mobile PPP parameters
Mobile telephone modules fitted into the router use PPP to connect to the network and send and
receive traffic. This section describes parameters relevant to setting up a mobile telephone
module.
Digi TransPort User Guide
Instance Parameter
n natip
n ipsec
n
n ipsecent
n ipsecadd
n firewall
n QoS
n use_modem
n cdma_backoff
n ndis
nocfg
n igmp
n ifspeed
n norxrst
Values Equivalent Web Parameter
Valid IP address NAT Source IP address a.b.c.d
a.b.c.d
0,1 Enable IPsec on this interface
0 = Off
1 = On
Keep Security Associations (SAs)
when this PPP interface is
disconnected
Default Use interface x,y for the source
PPP address of IPsec packets
Ethernet
Valid interface Use interface x,y for the source
number address of IPsec packets
OFF, ON Enable the firewall on this interface
0,1
Default: 1
Remote management access
0,1,2,3
0 = No restrictions
1 = Disable management
2 = Disable return RST
3 = Disable management and return
RST
OFF, ON Enable IGMP
64000 bps Allows the user to configure
the speed of the interface purely so
that it can be reported in SNMP. CLI
command only.
OFF, ON
Advanced Interfaces parameters
162