Isdn Parameters; Isdn Answering Parameters - Digi TransPort User Manual

Hide thumbs Also See for TransPort:
Table of Contents

Advertisement

Related CLI Commands
Entity
Instance
tun
n
tun
n
tun
n
tun
n
tun
n
tun
n
tun
n
tun
n
Note
RIP Routing Parameters – CLI only: Please note that under the CLI commands for GRE
Tunnels you will find parameters specifically relating to RIP. Please see the
Ethernet / PPP / GRE parameters
parameters.

ISDN parameters

The Configuration - Network > Interfaces > ISDN page has the following options:
ISDN Answering
ISDN Dialling
LAPD

ISDN Answering parameters

This page allows you to configure the ISDN interface to receive incoming calls.
Load answering defaults button
Click this to button resets the default answering PPP interface (PPP 0) to the factory answering
defaults.
Description
This parameter allows you to enter a name for this PPP instance, to make it easier to identify
it.
Only accept calls from calling numbers
ending with
Digi TransPort User Guide
Parameter
Values
metric
Numeric Metric
value
MTU
MTU value
tunkey
Key number
Firewall
on,off
csum
on,off
igmp
On, off
ipanon
On, off
tunanon
On, off
section on RIP routing for configuration of these sub
Equivalent Web Parameter
Metric for the route associated with
this interface
Maximum transmission unit size
Key number
Turn firewall on or off
Enable GRE checksums
Enable IGMP packets
Enable IP analysis for traffic on this
interface
Enable GRE tunnel analysis
ISDN parameters
Interfaces >
103

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TransPort and is the answer not in the manual?

Table of Contents