General Parameters - Digi TransPort User Manual

ntpstat rst

General parameters

You can configure you router functionalities that applies to the router in general rather than
specific features.
Autorun Commands
The router may be configured to run a number of commands once it has booted. These
commands are associated with specific asynchronous serial interfaces. Configuration of
this facility is via a table on this web page. As an example, it may be required that a
Script Basic script, sample.bas needs to be run at boot up. Auto commands are normally
associated with an ASY port, but running a script for example is not ASY port specific.
To configure the autorun commands, set the following values:
#
This parameter is the command interface to be associated with the command. In the above
example, this would be set to the number "0".
Command
This parameter is the CLI command to run on start-up. In the above example, this field would
be set to the string "bas sample.bas"
Related CLI commands.
Entity Instance
cmd n
Web / Command Line Interface
The router may be configured using several different methods. This section describes how to
configure the web GUI and CLI (Command Line Interface) options.
Digi TransPort User Guide
Parameter Values
autocmd Valid CLI command
General parameters
Equivalent Web Parameter
Autorun Commands
404