Digi TransPort User Manual page 251

Conversely, you may wish to only capture traffic to and from particular IP hosts. To do this, use
a tilde (~) symbol before the list of IP addresses. For example, to only capture packets to and
from IP host 192.168.47.1, enter "~192.168.47.1" for this parameter.
Forward debug to port
When enabled, the IKE debug is sent to debug serial port.
Related CLI commands
Entity
ike
ike
ike
IKE n parameters
Use the following settings for negotiation
This parameter defines the settings used during the IKE negotiation.
Encryption
This parameter defines the encryption algorithm used. The options are:
• None
• DES
• 3DES
• AES (128 bit keys)
• AES (192 bit keys)
• AES (256 bit keys)
Authentication
Defines the authentication algorithm used. The options are:
Digi TransPort User Guide
Instance Parameter
0 deblevel
0 ipaddfilt
0 debug
Values
0 = Off
1 = Low
2 = Medium
3 = High
4 = Very High
Comma separated list
of IP addresses
on, off
IPsec parameters
Equivalent Web Parameter
Debug Level
Debug IP Address Filter
Forward debug to port
251