Digi TransPort User Manual page 146

Selecting this option enables router to make a RealPort connection to a host PC.
Connect to host a.b.c.d Port n
This configures the IP address or hostname and TCP port that the router should use when
making a device initiated connection.
Allow s seconds between connection attempts
This configures the interval in seconds between device initiated connection attempts.
Send TCP Keep-Alives every s seconds
This configures the interval at which TCP Keep-Alives are sent over the RealPort connection. A
value of 0 means that Keep-Alives are not sent.
Send RealPort Keep-Alives every s seconds
This configures the interval at which RealPort Keep-Alives are sent over the RealPort
connection. A value of 0 means that Keep-Alives are not sent.
Enable exclusive mode
Selecting this option enables exclusive mode. Exclusive mode allows a single connection from
any one RealPort client ID to be connected only. If this setting is enabled and a subsequent
connection occurs that has the same source IP as an existing connection, the old existing
connection is forcibly reset under the assumption that it is stale.
Enable authentication
Selecting this option enables RealPort authentication.
Authentication secret
This configures the RealPort authentication secret.
Related CLI commands
Entity Instance
rport 0
rport 0
rport 0
rport 0
rport 0
rport 0
rport 0
rport 0
rport 0
Digi TransPort User Guide
Parameter Values
enabled OFF,ON
ipport 0 - 65535
maxnbsocks 0 - 255
encryption OFF,ON
encport 0 - 65535
maxnbencsocks 0 - 255
initiate OFF,ON
IPaddr Valid IP
address
a.b.c.d
initiateport 0 - 65535
Serial parameters
Equivalent Web Parameter
Enable RealPort
Listen on port
Maximum number of sockets
Enable encrypted RealPort
Encryption mode to listen on port
Maximum number of encryption
sockets
Enable Device Initiated RealPort
Connect to host a.b.c.d Port n
Connect to host a.b.c.d Port n
146