Openvpn Parameters - Digi TransPort User Manual

Entity
pptp
pptp
pptp
pptp
pptp

OpenVPN parameters

OpenVPN can be used for connecting to the router for secure management as well as access to
services on the LAN side of the TransPort router, such as corporate messaging services, file
servers and print servers for example.
OpenVPN is a full-featured SSL VPN which implements OSI layer 2 or 3 secure network extension
using the industry standard SSL/TLS protocol, supports flexible client authentication methods
based on certificates, smart cards, and/or username/password credentials, and allows user or
group-specific access control policies using firewall rules applied to the VPN virtual interface.
OpenVPN is not a web application proxy and does not operate through a web browser.
The Digi TransPort implementation of OpenVPN can be configured as an OpenVPN server (shown
above) or as an OpenVPN client, connecting to an OpenVPN server.
On TransPort firmware, OpenVPN has been implemented as an interface. That means that when
an OpenVPN tunnel connects, an interface is added to the routing table. Static routes may be
configured to point to an OpenVPN instance, and additionally, OpenVPN may learn routes from
the tunnel peer and add these routes to the routing table for the duration of the OpenVPN
tunnel. As each tunnel appears just like an interface, support for features like the firewall, NAT,
IGMP etc are the same as for other interfaces like PPP and ETH.
Digi TransPort User Guide
Instance Parameter
0 - 9 listen
0 - 9 swap_io
0 - 9 usesock
0 - 9 sslver
0 - 9 debug
Values
OFF,ON
OFF,ON
OFF,ON
Blank,SSL,TLS1,SSL3,
SSL2
Blank is disabled
(default)
SSL means use
default.
OFF,ON
OpenVPN parameters
Equivalent Web Parameter
Accept incoming PPTP connections
Enable Server mode
Enable Socket mode
Encrypt control data using SSL
version n
Enable PPTP debug
270