Reboot Command; Remote Connection - Digi TransPort User Manual

r_addr: OFF
r_callb: 0
rxtimeout: 23
rdoosdly: 0
restdel: 2000
rebootfails: 0
rip: 0
ripip:
ripauth: 1
ripis: OFF
r_md5: 1
r_ms1: 1
r_ms2: 1
rbcast: OFF
OK

Reboot command

The
reboot
modes of operation:
- will reboot the unit after any FLASH write operations have been completed. Also, 1
reboot
second each is allowed for the following operations to be completed before reboot will take
place:
• IPSec SA delete notifications have been created and sent
• TCP sockets have been closed
• PPP interfaces have been disconnected
reboot <n>
reboot cancel
Active port
When entering AT or text commands it is important to understand that in most cases, the
command only affects the settings for the active port. This is usually the port to which you are
physically connected but you may, if necessary, set the active port to another port of your choice
using the

Remote connection

Once you have finished configuring the unit, there are several ways of establishing a link to a
remote system:
• An outgoing V.120 call may be made using the ATD command
• You can initiate a DUN session to establish a dial-up PPP connection.
• An outgoing X.25 call may be made using the ATD command followed by the X.28 CALL
command.
Digi TransPort User Guide
command is used to reboot the unit after altering the configuration. It has three
- will reboot the unit in <n> minutes where n is 1 to 65,535
- will cancel a timed reboot if entered before the time period has passed.
command where N is 0-3.
AT\PORT=N
25