Universal Config.da0 Using Tags - Digi TransPort User Manual

To disable Serial devices from using either external USB port on a DR64x0, or on a port connected
to a hub on either these ports...
usbcon 0 dislist "usb-1-2*.SERIAL,usb-2-2*.SERIAL"
or
usbcon 0 dislist usb-?-2*.SERIAL
The enalist takes the same format but when matches it causes the device to be specifically
enabled. If a device matches the enable list as well as the disable list the enable list will take
preference.
When a device matches a list an event is written to the event log of the form...
"USB device usb-1-2.4.MSD disabled"
or
"USB device usb-1-2.4.MSD enabled"
in the case the device matches the enalist.
These events can be used to debug the correct matching string to match on when trying to
configure these parameters.
If both lists are left blank, all drivers are enabled and no extra events will appear in the event log.

Universal config.da0 using tags

The config.da0 contains a list of commands, one per line that are parsed at boot. The commands
in this file differ depending on the model of the router, the firmware in use and the hardware
options installed.
A single universal configuration file can be created with the use of tags, defining sections that
only relate to a specific hardware type or firmware version.
The tag values that can be used are:
• The base model, for example: DR6410
• The complete model, for example: DR6410-H0A
• The platform build string, for example: 8W
• The type of DSL, for example: DSL2, 2+
• The type of WWAN module detected, for example: E (Edge), C (CDMA)
• The complete WWAN module string, for example: MOTO_G24, SIEMENS_GPRS,
SIEMENS_MC75, NOVATEL_3G, SIERRA_3G, OPTION_3G, NOVATEL_CDMA, CMOTECH_CDMA,
SIERRA_CDMA
PSTN or ISDN module, for example: PSTN, ISDN
Tags must be used within angle brackets and the configuration sections must be opened AND
closed with the relevant tag, for example: To open <DR6410>, to close </DR6410>. Note the use
of the "/" in the closing tag.
To view a list of defined tags on a router, the CLI command tags can be used:
Example output of tags command:
Router>tags
tags defined:..
Digi TransPort User Guide
USB support
534