Digi TransPort User Manual page 444

Entity
gps
gps
Additional GPS CLI commands
cmd <instance> gpson {on|off}
When set to on, this indicates that an instance of the command line interpreter is connected to
the GPS receiver. The instance number should be the ASY port number to which the GPS receiver
is connected. This parameter has two purposes. Firstly, it tells a particular command interpreter
instance that it is connected to a GPS receiver so that commands received by that instance should
be ignored, rather than being treated as invalid commands. Secondly, it is used by the
command to determine where the GPS messages originate.
at\gps
This command causes messages from the GPS receiver to be sent directly to the ASY port from
which the command has been entered. This requires that the
"on" for one of the command interpreter instances. As soon as the
issued, data from the GPS receiver will be sent to that ASY port. In order to stop the GPS data, the
escape sequence must be entered, followed by a pause, followed by
+++
GPS support for the GOBI3000 module
GOBI3000 module supports the usage the GPS functionality. The GPS
configured with
gps 0 init_str $GPS_START
Also set the GPS
Digi TransPort User Guide
Instance Parameter
0 vtg_int
0 zda_int
.
$GPS_START
parameter to 3.
asy_add
Values
s seconds
0 – 255
s seconds
0 - 255
gpson
GPS parameters
Equivalent Web Parameter
n/a
n/a
at\gps
parameter (above) is set to
command has been
at\gps
.
at
string should be
init
444