Digi TransPort User Manual page 77

Hide thumbs Also See for TransPort:
Table of Contents

Advertisement

information is stored on the CDMA module. Therefore, you cannot remove provisioning
information from the CDMA module by performing a factory reset on your TransPort router.
If provisioning fails (the device does not obtain a phone number), contact the carrier and verify
that the device has an active account. You will need to provide the MEID of the device which is
available under Management - Network Status > Interfaces > Mobile. See
Provisioning on a Digi TransPort Router
Provider
If the router was not supplied pre-provisioned, obtain the following details from the Service
Provider:
a 15 digit IMSI (International Mobile Subscriber Identity)
an NAI (Network Access Identifier)
an NAI password
Once these details have been obtained, it is possible to provision the CDMA module by inserting
those details into the Automatic Provisioning section of this web page and clicking on the Start
button.
Automatic provisioning
Sprint Vision uses Automatic provisioning (semi-automatic). In most cases, the TransPort router
can be provisioned without entering any information into the configuration page. If for some
reason the TransPort router is an older version using a module that does not support OMA DM,
three fields of information must be entered into the Automatic configuration page. This
information is provided by Sprint.
If required, enter the MSL/PTN/MSID parameters before clicking Start
MSL
This parameter specifies master subsidy lock (MSL) code. You can obtain this from the mobile
operator.
PTN
This parameter specifies personal telephone number. You can obtain this from the mobile
operator.
MSID
Digi TransPort User Guide
for example configuration.
 
Mobile parameters
QN 25 CDMA
77

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TransPort and is the answer not in the manual?

Table of Contents