Tpad Parameters - Digi TransPort User Manual

Entity Instance
snaip x
snaip x
snaip x
snaip x
snaip x
snaip x
snaip x
snaip x
snaip x
snaip x
snaip x
snaip x
Forcing SNAIP to use a specific instance
If several SNAIP instances are sharing an ASY port, a switchover to a specific instance can be
initiated by issuing snasw x. Where x is the SNAIP instance number, this instance must be
available to go online or this command will fail.
To revert back and use the default instance, issue the snadis x command. Normal priorities will
be used to determine which SNAIP instance gets to use the SYNC port.

TPAD parameters

TPAD is a simplified version of the X.25 PAD specification that is commonly used for carrying out
credit-card clearance transactions. Digi units support the use of TPAD over:
•
ISDN B and D-channels
• TCP
• UDP
• SSL
• XoT
Digi TransPort User Guide
Parameter Values
sock_inact 0 - 2147483647
ver 0 - 2
passive 0 = active, 1 = passive
dlswwindow 1 - 100
udp_cap 1 = enabled, 0 =
disabled
use1sock On, Off, Compatible
inc_mac_exc 1 = enabled, 0 =
disabled
mac_exc_val 0 - 1
iunsolresp 1 = enabled, 0 =
disabled
waitforcont 1 = enabled, 0 =
act disabled
con_attemp 0 - 2147483647
ts
con_boff_ti 0 - 2147483647
me
TPAD parameters
Equivalent Web Parameter
Close TCP connection if it is
idle for x secs
DLSw Ver
DLSw Role
DLSw Window
UDP Capable
Use 1 socket
Include MAC Exclusivity
Capability
Mac Exclusivity Value
Ignore unsolicited response
frames
Wait for Contact before
progressing to CONNECT
PENDING state
Make immediate connection
attempts before backing off
Backoff for x seconds before
attempting to connect again
319