Transip Serial Ports Parameters - Digi TransPort User Manual

Hide thumbs Also See for TransPort:
Table of Contents

Advertisement

Currently it is only possible to bind a TANS instance to an ADAPT instance using the bind
command. The format of the command is:
bind adapt <instance> tans <instance>

TRANSIP Serial Ports parameters

TransIP is a way of using virtual serial ports for serial connections over an IP socket, in effect
multiplying the number of concurrent serial connections to a router. TransIP can be configured to
actively connect on a TCP socket (such as make outgoing connections).
The message at the top of this page states which serial interface is being used for the TransIP
connection.
Listen on port n
This parameter is the TCP port number that the router should listen on.
Connect to IP Address or Hostname a.b.c.d Port n
The IP address or hostname text entry box should contain a valid IP address or the hostname
which the router should use to make the outgoing TransIP connection.
If this parameter is set (such as non-zero), the number defined the TCP port number to use
when making TCP socket connections. When zero, TransIP is listening only on the port defined
above.
Send TCP Keep-Alives every s seconds
The value in this text entry box is the amount of time (in seconds) a connection stays open
without any traffic being passed.
Enable Stay Connected mode
When checked, this checkbox causes the router to refrain from clearing the TCP socket at the
end of a transaction, data call or data session (depending on what the TansIP serial port was
bound to and what protocol it was using). Leaving this checkbox unchecked allows the router
to clear the socket. For example, if the TransIP port is bound to a TPAD and the box is
unchecked, the TransIP TCP socket will be cleared at the end of the TPAD transaction.
Disable command echo
When this checkbox is checked command echo for the TransIP port is disabled. When
unchecked all commands issued will be echoed back to the TransIP TCP socket.
Escape char c
Digi TransPort User Guide
Serial parameters
143

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TransPort and is the answer not in the manual?

Table of Contents