Korg MICROX X50 Parameter Manual Page 156

Music synthesizer and synthesizer/controller.
Hide thumbs
Master EQ
Master EQ
Use the 9–4 MasterFX MEQ page in the Program, Combina-
tion, and Multi modes
You cannot use the Master EQ as the Insert Effect or as one
of the Master Effects.
Low
Mid
Left
LEQ
LEQ
Right
Low Gain Mod.
D
-mod
Low Gain Mod - Src
D
-mod
High Gain Mod - Src
Low Cutoff
Sets the cutoff frequency of Low EQ (shelving type)
a
Gain
Sets the gain of Low EQ
Mid Cutoff
Sets the cutoff frequency of Mid EQ (peaking type)
Q
b
Sets the band width of Mid EQ. With a higher value, the band
become narrower.
Gain
Sets the gain of Mid EQ
High Cutoff
Sets the cutoff frequency of High EQ (shelving type)
c
Gain
Sets the gain of High EQ
Low Gain Mod-Src
d
Selects the modulation source for Low Gain
High Gain Mod-Src
e
Selects the modulation source for High Gain
a: Gain, b: Gain, c: Gain
These parameters are linked with the "Master EQ Gain [dB]" (9–
1c) parameter of the MasterFX.
d: Low Gain Mod-Src
For example, when this parameter is set to Kb1#17, you can con-
trol the EQ gain in the range from –18dB to +18dB during perfor-
mance using the [REALTIME CONTROLS] knob. At this time, set
Knob 1-B to Knob Mod1 (CC#17) for "Knob B-Assign" (PROG 7–
3a, COMBI 7–5a, MULTI 7–6a). The 12 o'clock position of the knob
corresponds to the "Low Gain" value here.
e: High Gain Mod-Src
For example, when this parameter is set to Kb2#19, you can con-
trol the EQ gain in the range from –18dB to +18dB during perfor-
mance using the [REALTIME CONTROLS] knob. At this time, set
Knob 2-B to Knob Mod2 (CC#19) for "Knob B-Assign" (PROG 7–
3a, COMBI 7–5a, MULTI 7–6a). The 12 o'clock position of the knob
corresponds to the High Gain value here.
High
L/Mono
PEQ
HEQ
PEQ
HEQ
R
High Gain Mod.
20...1.00KHz
–18.0...+18.0 (0.5step)dB
300...10.00KHz
0.5...10.0 (0.1step)
–18.0...+18.0 (0.5step)dB
500...20.00KHz
–18.0...+18.0 (0.5step)dB
Off...Tempo
Off...Tempo
149

Advertising

   Also See for Korg MICROX X50

   Related Manuals for Korg MICROX X50

This manual also for:

Micro x

Comments to this Manuals

Symbols: 0
Latest comments: