05: St.gate (Stereo Gate); 06: Od/Higain Wah; (Overdrive/Hi.gain Wah) - Korg MICROX X50 Parameter Manual

Music synthesizer and synthesizer/controller
Hide thumbs Also See for MICROX X50:
Table of Contents

Advertisement

W/D (Wet/Dly)
Sets the balance between the effect and dry sounds
(Source)
i
Selects the modulation source of the effect balance
(Amount)
Sets the modulation amount of the effect balance
e: Low Offset, f: Mid Offset, g: High Offset
These parameters set the gain of the trigger signal.
For example, if you do not want to apply compression to the high
range, reduce the "High Offset" value down below the "Thresh-
old" level. In this way, the high range limiter will not respond,
and compression will not be applied.
05: St.Gate
This effect mutes the input signal if its level is lower than the
specified level. It also reverses the on and off operation of the
gate, and uses Note On and Off messages to turn the gate on
and off.
Stereo In - Stereo Out
Left
+
Envelope Select
Right
Gate+Dmpr
Envelope (Envelope Select)
a
Selects from Control via the modulation source, mixing the left and
right signals, Only left, and Only right
Env. Dmod Src (Envelope Dmod Source)
b
Selects the modulation source that controls the gate when Envelope
= Dmod
Threshold
c
Sets the level to which the Gate is applied
Attack
d
Sets the attack time
Release
e
Sets the release time
Polarity
f
Switches between non-reversed and reversed Gate on/off
Delay (Delay Time)
g
Sets the delay time of the gate input
W/D (Wet/Dly)
Sets the balance between the effect and dry sounds
(Source)
h
Selects the modulation source of the effect balance
(Amount)
Sets the modulation amount of the effect balance
a: Envelope, b: Env. Dmod Src
The "Envelope" parameter selects whether the gate on/off is trig-
gered by the level of the input signal, or controlled directly by the
modulation source. The Src parameter specifies the modulation
source, selected from Off to G2+Dmod.
With "Envelope" = L/R Mix, the left and right channel signal mix-
ture will trigger the gate on/off. When L Only or R Only is
selected, the gate is controlled by either of the channel signals.
f: Polarity
This parameter reverses the Gate on/off operation. With a nega-
tive value, the gate is closed when the input signal level exceeds
the Threshold. The gate operation controlled by the modulation
source is also reversed.
106
Dry, 1:99...99:1, Wet
(Stereo Gate)
Delay
Gate
Envelope - Control
Envelope - Control
Delay
Gate
Dmod, L/R Mix, L Only, R Only
Off...G2+Dmp
Dry, 1:99...99:1, Wet
c: Threshold, d: Attack, e: Release
This parameter sets the signal level below which Gate is applied
when "Envelope" is set to L/R Mix, L Only, or R Only.
Off...Tempo
The Attack and Release parameters set the Gate attack time and
release time.
–100...+100
Wet / Dry
g: Delay
This parameter sets the delay time of the Gate input. If the sound
has a very fast attack, increase the delay time so that the signal
will be input after the Gate is opened. This will preserve the attack
Wet / Dry
part of the sound.

06: OD/HiGain Wah

☞,

(Overdrive/Hi.Gain Wah)

This distortion effect utilizes an Overdrive mode and a Hi-
0...100
Gain mode. Controlling the wah effect, the 3-band EQ, and
the amp simulation will allow you to create versatile distor-
1...100
tion sounds. This effect is suitable for guitar and organ
sounds.
1...100
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
Left
+, –
0...100ms
Pre Low-cut
+
Off...Tempo
Right
D
-mod
–100...+100
Wah
Switches Wah on/off
(Source)
a
Selects the modulation source that switches the Wah on and off
(Sw)
Selects the switching mode for the modulation source that switches
the Wah on and off
Sweep Rng (Wah Sweep Range)
Sets the range of Wah
b
Src (Source)
Selects the modulation source that controls the Wah
Mode (Drive Mode)
Switches between overdrive and hi-gain distortion
c
Drive
Sets the degree of distortion
Pre Low-cut
d
Sets the low range cut amount of the distortion input
Output Level
Threshold
Louder
Input Level
Gate - Attack / Release
Dry
Wet
Wet
Attack
Release
Mode: Overdrive / Hi-Gain
Drive
3 Band PEQ
Driver
Amp Simulation
Wah
Output Level
Direct Mix
Gate - Threshold
Threshold
Attack=1
Release=1
Attack=100
Release=100
Wet / Dry
Wet / Dry
Off, On
☞,
Off...Tempo
Tggl, Mmnt
–10...+10
☞,
Off...Tempo
Overdrive, Hi-Gain
1...100
0...10

Advertisement

Table of Contents
loading

This manual is also suitable for:

Micro x

Table of Contents