7–3: Arp. A
7–4: Arp. B
Indicates settings for arpeggiator A in the Arp. A page, and
for arpeggiator B in the Arp. B page.
You can use the "Copy Arpeggiator" utility to copy set-
tings from another mode such as Program mode.
7–3a
7–3(4)a: Arpeggiator–A (B) Setup
Pattern
[Preset-0...Preset-4, U000...U250]
Octave
Reso (Resolution)
Gate
Velocity
Swing
Sort
Latch
Key Sync.
Keyboard
These are the arpeggiator parameters for the multi set.
(☞PROG 7: Ed–Arp/Ctrls)
■ 7–3(4): UTILITY
☞"Write Multi," "Copy From Combi" (0–1), "Copy Arpeg-
giator" (COMBI 7–1)
70
(Arpeggiator A)
(Arpeggiator B)
[1, 2, 3, 4]
[
,
,
,
[000...100(%), Step]
[001...127, Key, Step]
[–100...+100(%)]
[Off, On]
[Off, On]
[Off, On]
[Off, On]
7–5: Zone
Specifies the range of notes and velocities that will trigger
each arpeggiator A and B.
7–5a
7–5a: Scan Zone A/B
Zone Map
This shows the "Scan Zone" settings for arpeggiators A and
B (☞COMBI 7–4a).
A: Key
Btm (A-Bottom Key)
Top (A-Top Key)
,
, ]
Specifies the range of notes (keys) that will trigger
arpeggiator A. "Top" is the upper limit, and "Btm" is the
lower limit.
A: Vel (Velocity)
Btm (A-Bottom Velocity)
Top (A-Top Velocity)
Specifies the range of velocities that will trigger arpeggiator
A. "Top" is the upper limit, and "Btm" is the lower limit.
B: Key
Btm (B-Bottom Key)
Top (B-Top Key)
B: Vel (Velocity)
Btm (B-Bottom Velocity)
Top (B-Top Velocity)
Specifies the range of notes (keys) and velocities that will
trigger arpeggiator B (☞"A: Key," "A: Vel").
X50:
The value of these parameters can also be set by hold-
ing down the [ENTER] button and playing a note on a con-
nected MIDI instrument.
■ 7–5: UTILITY
☞"Write Multi," "Copy From Combi" (0–1), "Copy Arpeg-
giator" (COMBI 7–1)
(Scan Zone)
[C–1...G9]
[C–1...G9]
[001...127]
[001...127]
[C–1...G9]
[C–1...G9]
[001...127]
[001...127]