37: Detune; 38: Pitch Shifter - Korg MICROX X50 Parameter Manual

Music synthesizer and synthesizer/controller
Hide thumbs Also See for MICROX X50:
Table of Contents

Advertisement

37: Detune

Using this effect, you can obtain a detune effect that offsets
the pitch of the effect sound slightly from the pitch of the
input signal. Compared to the chorus effect, a more natural
sound thickness will be created.
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
Left
Input Level
+
Detune
Input Level
Right
Sft (Pitch Shift)
Sets the pitch difference from the input signal
(Source)
a
Selects the modulation source of the pitch shift
(Amount)
Sets the modulation amount of the pitch shift
Delay (Delay Time)
b
Sets the delay time
Feedback
c
Sets the feedback amount
High Damp
d
Sets the damping amount in the high range
InLvl Mod (Input Level Dmod [%])
Sets the modulation amount of the input level
e
Src (Source)
Selects the modulation source for the input level
W/D (Wet/Dly)
Sets the balance between the effect and dry sounds
(Source)
f
Selects the modulation source of the effect balance
(Amount)
Sets the modulation amount of the effect balance
e: InLvl Mod, e: Src
This parameter sets the dynamic modulation of the input level.
Input Level
Input Level
x1.0
Amt= +50
Amt= +100
x0.5
D
-mod
Higher
Zero
Max
Wet / Dry
High Damp
Delay
Feedback
Wet / Dry
–100...+100cent
Off...Tempo
–100...+100cent
0...1000ms
–100...+100
0...100%
–100...+100
☞,
Off...Tempo
Dry, 1:99...99:1, Wet
Off...Tempo
–100...+100
Input Level D-mod
x1.0
Amt= –50
Amt= –100
x0.5
D
-mod
Higher
Zero
Max

38: Pitch Shifter

This effect changes the pitch of the input signal. You can select
from three types: Fast (quick response), Medium, and Slow
(preserves tonal quality). You can also create an effect in
which the pitch is gradually raised (or dropped) using the
delay with feedback.
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
Left
Input Level
+
Pitch Shifter
Post
Pre
Feedback Position
Input Level
Right
Mode
a
Switches Pitch Shifter mode
Shift (Pitch Shift)
Sets the pitch shift amount by steps of a semitone
(Source)
b
Selects the modulation source of pitch shift amount
(Amount)
Sets the modulation amount of pitch shift amount
Fine
Sets the pitch shift amount by steps of a cent
c
(Amount)
Sets the modulation amount of pitch shift amount
Delay (Delay Time)
d
Sets the delay time
Feedback Position
e
Switches the feedback connection.
Feedback
Sets the feedback amount
f
HiDamp (High Damp)
Sets the damping amount in the high range
InLvl Mod (Input Level Dmod [%])
Sets the modulation amount of the input level
g
Src (Source)
Selects the modulation source for the input level
W/D (Wet/Dly)
Sets the balance between the effect and dry sounds
(Source)
h
Selects the modulation source of the effect balance
(Amount)
Sets the modulation amount of the effect balance
a: Mode
This parameter switches the pitch shifter operating mode. With
Slow, tonal quality will not be changed too much. With Fast, the
effect becomes a Pitch Shifter that has a quick response, but may
change the tone. Medium is in between these two. If you do not
need to set too much pitch shift amount, set this parameter to
Slow. If you wish to change the pitch significantly, use Fast.
b: Shift, b: (Source), b: (Amount), c: Fine, c: (Amount)
The amount of pitch shift will use the value of the "Shift" plus the
"Fine" value. The amount of modulation will use the c: (Amount)
value plus d: "(Amount)."
Modulation Source is used both for "Shift" and "Fine."
e: Feedback Position, f: Feedback
When "Feedback Position" is set to Pre, the pitch shifter output is
again input to the pitch shifter. Therefore, if you specify a higher
value for the Feedback parameter, the pitch will be raised (or low-
ered) more and more each time feedback is repeated.
If "Feedback Position" is set to Post, the feedback signal will not
pass through the pitch shifter again. Even if you specify a higher
value for the Feedback parameter, the pitch-shifted sound will be
repeated at the same pitch.
Wet / Dry
High Damp
Delay
Feedback
Wet / Dry
Slow, Medium, Fast
–24...+24
☞,
Off...Tempo
–24...+24
–100...+100cent
☞,
–100...+100cent
0...1000ms
Pre, Post
–100...+100
0...100%
–100...+100
☞ Fx:37,
Off...Tempo
☞ Fx:37
Dry, 1:99...99:1, Wet
Off...Tempo
–100...+100
125

Advertisement

Table of Contents
loading

This manual is also suitable for:

Micro x

Table of Contents