Korg MICROX X50 Parameter Manual Page 123

Music synthesizer and synthesizer/controller.
Hide thumbs

Advertisement

22: St.Env.Flanger
(Stereo Envelope Flanger)
This Flanger uses an envelope generator for modulation. You
will obtain the same pattern of flanging each time you play.
You can also control the Flanger directly using the modula-
tion source.
Stereo In - Stereo Out
Left
Right
D-mod
D
-mod
EG Attack/Decay
L Dly Bottom (L Delay Bottom)
a
Sets the lower limit of the delay time on the left channel
L Dly Top (L Delay Top)
b
Sets the upper limit of the delay time on the left channel
R Dly Bottom (R Delay Bottom)
c
Sets the lower limit of the delay time on the right channel
R Dly Top (R Delay Top)
d
Sets the upper limit of the delay time on the right channel
Swp Mode (Sweep Mode)
Determines whether the flanger is controlled by the envelope gener-
ator or by the modulation source
e
Src (Source)
Selects the modulation source that triggers the EG (when EG is
selected for Swp Mode), or modulation source that causes the
flanger to sweep (when Dmod is selected for Swp Mode)
EG Attack
f
Sets the EG attack speed
EG Decay
g
Sets the EG decay speed
Feedback
h
Sets the feedback amount
High Damp
i
Sets the feedback damping amount in the high range
W/D (Wet/Dly)
Sets the balance between the effect and dry sounds
j
(Source)
Selects the modulation source of the effect balance
(Amount)
Sets the modulation amount of the effect balance
e: Swp Mode, e: Src
This parameter switches the flanger control mode. With "Swp
Mode" = EG, the flanger will sweep using the envelope generator.
This envelope generator is included in the envelope flanger, and
not related to the Pitch EG, Filter EG, or Amp EG.
The "Src" parameter selects the source that starts the envelope
generator. If you select, for example, Gate, the envelope generator
will start when the note-on message is received.
When "Swp Mode" = Dmod, the modulation source can control
the flanger directly. Select the modulation source using the "Src"
parameter.
The effect is off when a value for the modulation source
specified for the "Src" parameter is smaller than 64, and the
effect is on when the value is 64 or higher. The Envelope
Generator is triggered when the value changes from 63 or
smaller to 64 or higher.
f: EG Attack, g: EG Decay
Attack and Decay speed are the only adjustable parameters on
this EG.
116
Flanger
Feedback
High Damp
Flanger
Sweep Mode
EG
–Wet...–1:99, Dry, 1:99...Wet
☞ Fx:10, 20,
23: St.Phaser
This effect creates a swell by shifting the phase. It is very
effective on electric piano sounds. You can add spread to the
sound by offsetting the phase of the left and right LFOs from
each other.
Stereo In - Stereo Out
Left
Wet / Dry
Right
LFO: Tri / Sine
Wet / Dry
LFO Wave (LFO Waveform)
Selects LFO Waveform
a
0.0...50.0ms
Shape (LFO Shape)
☞ Fx:09
Determines how much the LFO waveform is changed
0.0...50.0ms
LFO Phase
b
☞ Fx:09
Sets the LFO phase difference between the left and right
0.0...50.0ms
Freq (LFO Frequency)
☞ Fx:09
Sets the LFO speed
0.0...50.0ms
(Source)
c
☞ Fx:09
Selects the modulation source of LFO speed
EG, Dmod
(Amount)
Sets the modulation amount of LFO speed
☞,
BPM/MIDI Sync
Off...Tempo
Switches between using the frequency of the LFO speed and using
the tempo and notes
BPM
Selects MIDI Clock and assigns tempo
d
1...100
Base (Base Note)
Selects the type of notes that specify the LFO speed
1...100
Times
Sets the number of notes that specify the LFO speed
–100...+100
☞ Fx:20
Manual
e
Sets the frequency to which the effect is applied
0...100%
☞ Fx:20
Depth
Sets the depth of LFO modulation
(Source)
f
Selects the modulation source for the LFO modulation depth
(Amount)
Off...Tempo
Sets the modulation amount of the LFO modulation depth
Resonance
–100...+100
g
Sets the resonance amount
High Damp [%]
h
Sets the resonance damping amount in the high range
W/D (Wet/Dly)
Sets the balance between the effect and dry sounds
i
(Source)
Selects the modulation source of the effect balance
(Amount)
Sets the modulation amount of the effect balance
g: Resonance, i: W/D
The peak shape of the positive and negative Feedback value is dif-
ferent. The harmonics will be emphasized when the effect sound
is mixed with the dry sound, if you set a positive value for both
"Resonance" and "W/D", and if you set a negative value for both
"Resonance" and "W/D".
h: High Damp
This parameter sets the amount of damping of the resonance in
the high range. Increasing the value will cut high-range harmon-
ics.
(Stereo Phaser)
Phaser
Resonance
High Damp
Phaser
LFO Phase
LFO Shape
–180...+180deg
☞ Fx:09,
–20.00...+20.00Hz
☞ Fx:09,
–Wet...–1:99, Dry, 1:99...Wet
☞ Fx:10,
Wet / Dry
Wet / Dry
Tri, Sine
–100...+100
☞ Fx:20
☞ Fx:10
0.02...20.00Hz
Off...Tempo
Off, On
MIDI, 40...240
☞ Fx:09
☞ Fx:09
1...16
☞ Fx:09
0...100
0...100
Off...Tempo
–100...+100
–100...+100
0...100%
Off...Tempo
–100...+100

Advertisement

   Also See for Korg MICROX X50

   Related Manuals for Korg MICROX X50

This manual also for:

Micro x

Comments to this Manuals

Symbols: 0
Latest comments: