9-2: Mfx1 (Master Effect1); 9-3: Mfx2 (Master Effect2); 9-4: Meq (Master Eq) - Korg MICROX X50 Parameter Manual

Music synthesizer and synthesizer/controller
Hide thumbs Also See for MICROX X50:
Table of Contents

Advertisement

9–1d: MEQ Ctrl
MEQ Ctrl (MEQ Control Ch) [Ch01...16, G ch]
Specifies the MIDI channel that will control dynamic
modulation (Dmod) for the master EQ.
G ch: The effect will be controlled on the global MIDI chan-
nel "MIDI Channel" (GLOBAL 1–1a).
■ 9–1: UTILITY
☞"Write Multi" (0–1), "Select by Category" (PROG 9–1)
Copy Master Effect
☞p.30 PROG 9–1
Note, the MIDI control channel specified in "Control
Channel" of the MFX 1 and 2 pages will not be copied.
Swap Master Effect
☞p.31 PROG 9–1
Note, the MIDI control channel specified in "Control
Channel" of the MFX 1 and 2 pages will not be
swapped.
9–2: MFX1
9–3: MFX2
Here you can set the parameters of the "Master Effect1" and
"Master Effect2" effects that were selected in the Setup page
(☞p.104–).
■ 9–2(3): UTILITY
☞"Write Multi" (0–1)
74
(Master Effect1)
(Master Effect2)
9–4: MEQ
(Master EQ)
The master EQ is a three-band stereo EQ. It is used to per-
form overall equalizing (tonal adjustment) on the sound
from the L/R bus immediately before it is output to (MAIN
OUTPUT) L/MONO and R (☞p.149).
■ 9–4: UTILITY
☞"Write Multi" (0–1)

Advertisement

Table of Contents
loading

This manual is also suitable for:

Micro x

Table of Contents