Korg MICROX X50 Parameter Manual: Ifx (insert Effect); Combi 9: Ed–masterfx; Setup

Music synthesizer and synthesizer/controller.
Hide thumbs
8–3: IFX
(Insert Effect)
Here you can adjust the parameters for the IFX that was
selected in the Setup page (☞p.104–).
■ 8–3a: UTILITY
☞"Write Combination" (0–1)
52
COMBI 9: Ed–MasterFX
☞For details on master effects, refer to p.97 "6. Effect
Guide."
9–1: Setup
Here you can select the type of each master effect, turn it
on/off, and make chain and master EQ settings.
With the exception of "MFX1 Control Ch," "MFX2 Control
Ch," and "MEQ Control Ch," this is the same as in Program
mode. (☞PROG 9: Ed–MasterFX)
9–1a
9–1b
9–1a: MasterFX Setup
MFX1 On/Off, MFX2 On/Off
Master Effect 1, 2
Rtn 1, 2 (Return 1, 2)
These are the same as in Program mode. Refer to "PROG 9–
1: Setup." However, the master effects will be controlled on
the "MFX 1, 2 Control Ch" MIDI channel, unlike in Program
mode.
The control changes used are the same as in Program mode.
MFX 1, 2 Control Ch
Selects the MIDI channel that will control dynamic
modulation (Dmod) for the master effects.
G ch: The global MIDI channel "MIDI Channel" (GLOBAL
1–1a) will be used for control. Normally you will set this
parameter to G ch.
9–1b: MasterFX Chain
MFX Chain
Direction (Chain Direction)
[MFX1→MFX2, MFX2→MFX1]
Signal (Chain Signal) [LR Mix, L Only, R Only]
Level (Chain Level)
These are the same as in Program mode. (☞PROG 9–1:
Setup)
9–1c: Master EQ Gain [dB]
Low
Mid
High
These are the same as in Program mode. (☞PROG 9–1:
Setup)
9–1d
9–1c
[Off, On]
[00...89: name]
[000...127]
[Ch01...16, G ch]
[Off, On]
[000...127]
[–18.0...+18.0]
[–18.0...+18.0]
[–18.0...+18.0]

Advertising

   Also See for Korg MICROX X50

   Related Manuals for Korg MICROX X50

This manual also for:

Micro x

Comments to this Manuals

Symbols: 0
Latest comments: