Prog 1: Ed-Basic; 1-1: Basic (Prog Basic) - Korg MICROX X50 Parameter Manual

Music synthesizer and synthesizer/controller
Hide thumbs Also See for MICROX X50:
Table of Contents

Advertisement

PROG 1: Ed–Basic
Here you can make basic settings for the oscillator(s).
1–1: Basic
1–1a
1–1b
1–1c
1–1a: Oscillator
Mode (Oscillator Mode)
Specifies the basic program type; whether it will use one or
two oscillators, or a drum kit.
Single: The program will use one oscillator (Oscillator 1,
Filter 1, Amplifier 1). In this case the program will have a
maximum of 62-note polyphony.
Double: The program will use two oscillators (Oscillator 1/
2, Filter 1/2, Amplifier 1/2). Allowing you to create more
complex sounds. In this case the program will have a 31-
note maximum polyphony.
Drums: The program will use one oscillator (as when Sin-
gle is selected), but Oscillator 1 will be assigned a drum kit
instead of a multisample. In this case the program will have
a maximum of 62-notes of polyphony.
1–1b: Voice Assign
Mode (Voice Assign Mode)
Poly: The program will play polyphonically, allowing you
play chords.
Mono: The program will play monophonically, producing
only one note at a time.
Hold
On (checked): Hold is On. Even when you take your finger
off of the key, the note will continue sounding as if it contin-
ued to be held. Unless the "Amp1 EG", "Amp2 EG" (6–3, 6–
6) "S (Sustain Level)" is set to 0, the sound will continue
playing.
This is ideal for playing drum sounds, If you set "Mode
(Oscillator Mode)" (1–1a) to Drums, you should normally
turn Hold On.
Off (unchecked): Hold is Off. Except for drum programs,
you should normally set Hold Off.
If you turn "Hold" On for a drum program, keys of the
selected drum kit whose "Enable Note Off" parameter
(GLOBAL 4–3a) is unchecked will be set to Hold On.
Keys that are checked will be set to Hold Off. If you
select Hold Off, the keys will be set to Hold Off regard-
less of their "Enable Note Off" setting.
Single Trigger
This is available when the "Mode (Voice Assign Mode)" set-
ting is set to Poly.
6
(Prog Basic)
[Single, Double, Drums]
[Poly, Mono]
On (checked): When the same note is played repeatedly, the
previous note will be silenced before the next note is
sounded, so that the notes do not overlap.
Legato
This is available when the "Mode (Voice Assign Mode)" set-
ting is set to Mono.
On (checked): Legato is on. When multiple note-on mes-
sages occur, the first note-on will retrigger the sound, and
the second and subsequent note-ons will not retrigger.
When legato is on, multiple note-on message will not retrig-
ger the voice. If one note is already on and another note is
turned on, the oscillator sound, envelope, and LFO will not
be reset, and only the pitch of the oscillator will be updated.
This setting is effective for wind instrument sounds and
analog synth-type sounds.
Off (unchecked): Legato is off. Notes will always be retrig-
gered when note-on occurs.
When legato is off, multiple note-on's will retrigger the
voice at each note-on. The oscillator sound, envelope, and
LFO will be reset (and retriggered) according to the settings
of the program.
If "Legato" is checked, certain multisamples or key-
board locations may produce an incorrect pitch.
Priority
This parameter is valid when "Mode (Voice Assign Mode)"
is set to Mono.
It specifies which note will be given priority to play when
two or more notes are played simultaneously.
Low: Lowest note will take priority.
High: Highest note will take priority.
Last: Last note will take priority.
1–1c: Scale
Type (Scale Type)
[Equal Temperament...User Octave 15]
Indicates the basic scale for the internal tone generator.
Equal Temperament: This is the most widely used scale,
where each semitone step is spaced at equal pitch intervals.
Pure Major: In this temperament, major chords of the
selected tonic will be perfectly in tune.
[Off, On]
Pure Minor: In this temperament, minor chords of the
selected tonic will be perfectly in tune.
Arabic: This scale includes the quarter-tone scale used in
Arabic music.
Pythagoras: This scale is based on ancient Greek musical
theory, and is especially effective for playing melodies.
Werkmeister (Werkmeister III): This is an equal tempered
scale that was used since the later Baroque period.
Kirnberger (Kirnberger III): This scale was created in the
18th century, and is used mainly to tune harpsichords.
Slendro: This is an Indonesian gamelan scale in which an
octave consists of five notes.
When "Key" is set to C, use the C, D, F, G and A notes.
(Other keys will sound equal-tempered pitches.)
Pelog: This is an Indonesian gamelan scale in which an
octave consists of seven notes.
[Off, On]
When "Key" is set to C, use the white keys. (The black keys
will sound the equal tempered pitches.)
Stretch: This tuning is used for acoustic pianos.
[Off, On]
[Low, High, Last]

Advertisement

Table of Contents
loading

This manual is also suitable for:

Micro x

Table of Contents