Shift Lever; Frame/Welds; Electrical Connections; Hydraulic Brake System - Arctic Cat Prowler Service Manual

B. 2WD/4WD selector switch — differential will
engage (4WD)/disengage (2WD).
C. Reverse/neutral/high/low switch — R/N/H/L
will be indicated on the LCD.
D. Headlight switch — high beam, low beam, and
lights off can be selected.
E. Brake switch — brakelight illuminates and
starter can be engaged with vehicle in gear.

Shift Lever

CHECKING SHIFT LEVER LINKAGE
Set the parking brake and turn the ignition switch on;
then with the shift lever in the neutral position, look
for the (N) indication on the LCD. Shift into high
range and look for the (H) indication, low range for the
(L) indication, and reverse for the (R) indication. Shift
the transmission into neutral and turn the ignition
switch off.
ADJUSTING SHIFT LEVER LINKAGE
To adjust the shift lever linkage, use the following pro-
cedure.
1. Set the parking brake; then remove the seats and
center console.
2. Make sure the shift lever is in neutral; then loosen
the jam nut on the linkage.
3. Remove the E-clip on the transmission shift arm;
then remove the linkage from the shift arm.
Account for a washer and a bushing.
Back
PR094
Back to TOC
4. Turn the linkage rod clockwise or counterclock-
wise until the lower linkage hole aligns with the
shift arm pin.
5. Install the bushing and linkage and secure with the
washer and E-clip; then tighten the jam nut
securely. Check each gear shift position for proper
gear selection and make sure the proper icon illu-
minates on the LCD.

Frame/Welds

The frame and welds should be checked periodically
for damage, bends, cracks, deterioration, broken com-
ponents, and missing components. If replacement or
repair constitutes removal, see Section 8.

Electrical Connections

The electrical connections should be checked periodi-
cally for proper function. In case of an electrical fail-
ure, check fuses, connections (for tightness, corrosion,
damage), and/or bulbs. If an electrical component
needs to be tested for proper function, see Section 5.

Hydraulic Brake System

CHECKING/BLEEDING
The hydraulic brake system has been filled and bled at
the factory. To check and/or bleed a hydraulic brake
system, use the following procedure.
1. With the master cylinder in a level position, check
the fluid level in the reservoir. If the level in the
reservoir is not above the MIN, add DOT 4 brake
fluid.
Back to Section TOC
PR461A
2
Next
2-13