Reporting Summary - GE NetworX V3 Installation Manual

GPRS connection.
The connection is made via a TCP/IP network. Instead of a phone number, an IP address is set. The
Callback Required and Allow Calls From options are ignored.
Navigate with the
1.
connection type and must be done before the phone number and IP address can be
programmed.
Navigate with the
2.
OK.
Press # to clear the current value.
3.
Enter the IP Address and press OK.
4.
Navigate with the
5.
Port and press OK
Select the U/D port and press OK.
6.
Note: When GPRS reporting (TCP/IP) is set then is recommended to use the TCP/IP Up/Download (by default
Up/Download is set to CSD). This will cause the 7002 to be connected to GPRS, and reporting will be faster
and cheaper.

Reporting summary

The following table summarises the programming information required for different types of
reporting.
Table 25. Reporting Summary
Report type
Contact ID over SMS
SIA over SMS
keys to Up/Download>Connection Type>TCP/IP. This sets the
keys to NX-7002 Module>Up/Download>IP Address and press
keys to NX-7002 Module>Options>Network>Port Numbers>U/D
Information Menu Option
required
Phone Number Select NX-7002 Module>Reporting>SMS Reporting>Receiver n>Phone
number.
Account code Select NX-7002 Module>Reporting>SMS Reporting>Receiver n>Account
Code.
Protocol Select NX-7002 Module>Reporting>SMS Reporting>Receiver
n>Protocol>Contact ID.
Destination Select NX-7002 Module>Reporting>Report Control>Report
n>Destination>SMS1 or SMS 2.
SMS Service Select NX-7002 Module>Options>GSM>SMS Service Center Address.
Centre
Phone Number Select NX-7002 Module>Reporting>SMS Reporting>Receiver n>Phone
number.
Account code Select NX-7002 Module>Reporting>SMS Reporting>Receiver n>Account
Code.
Protocol Select NX-7002 Module>Reporting>SMS Reporting>Receiver
n>Protocol.
Select SIA Separate, SIA Combined or SIA Partition Modified.
Destination Select NX-7002 Module>Reporting>Report Control>Report
n>Destination>SMS1 or SMS 2.
NetworX Version 3 Installation Manual
203