GE NetworX V3 Installation Manual page 219

Term Definition
Good RSSI An Options setting that indicates that the current RSSI level is equal to or greater than the minimum
signal quality level configured in Line Fault RF Level. If the RSSI level drops below this value a GSM line
fault is indicated.
GPRS General Packet Radio Service. A global standard for wireless communications. It supports a range of
bandwidths and can transmit and receive both small bursts and large amounts of data.
An Options menu entry that allows a GPRS connection for up/download.
GPRS APN An Options setting that configures the GPRS access point name. Contact the network provider to
obtain this name. This is a mandatory setting if using TCP/IP reporting.
An Options setting that configures a second GPRS access point name. Contact the network provider
GPRS APN 2
to obtain this name. This is used if the connection cannot be made via the GPRS APN.
GPRS Connected An Options setting that indicates that the module is logged into the GPRS network.
GPRS Disconnect This contains the length of time with no activity before the GPRS disconnects.
Delay
GSM Global System for Mobile Communications. A global standard for wireless communications. It
supports narrowband Time Division Multiple Access (TDMA).
An Options menu entry that groups GSM connection options.
GSM Connection An Options menu entry that groups GSM connection settings.
GSM Engine Comms An Options setting that indicates that communication with the GSM module is established.
GSM Engine Info An Options menu entry that groups information returned from the on-board GSM module on the GSM
module.
GSM Operator An Options menu entry that groups information on the current GSM operator and allows a specific
GSM operator to be manually selected.
H
Hit 24H Report Limit An Options setting that indicates that the maximum number of reports allowed in 24 hours has been
reached. This applies to SMS and GPRS reports.
HomeText An Options menu entry that groups together HomeText information,
HomeText Control An Options setting that enables or disables HomeText.
I
IP Address A Reporting setting that configures the address of the selected TCP/IP receiver.
An Up/download setting that configures the address of the selected TCP/IP receiver.
K
Keypad for Zone Text An Options setting that selects the keypad from which zone and user names are obtained.
L
Language A Reporting setting that sets the language used for SMS messages.
Line Fault Delay An Options setting that configures the length of time the RSSI signal must be below the Line Fault RF
Level before a line fault is generated. This can be from 0 to 255 seconds.
Line Fault Indication A Reporting setting that enables the display of GSM/GPRS line faults.
Line Fault Reporting A Reporting setting that enables the reporting of GSM/GPRS line faults.
NetworX Version 3 Installation Manual
219