GE NetworX V3 Installation Manual page 123

LOCATION 88 - ACCOUNT CODE FOR PARTITION 1 (6 segments, numerical data)
Location 88 contains the account code that is sent when partition 1 is reported. If location 88 is left
unprogrammed (all "10"s), then the account code corresponding to the phone number that is dialled
will be used. If the account code is less than six digits, program a "10" in the segment immediately
after the last digit of the account code. If the account code is 6 digits long, program all 6 segments.
LOCATION 89 - ACCOUNT CODE FOR PARTITION 2 (6 segments, numerical data)
Location 89 contains the account code that is sent when partition 2 is reported. If location 89 is left
unprogrammed (all "10"s), then the account code corresponding to the phone number that is dialled
will be used. If the account code is less than six digits, program a "10" in the segment immediately
after the last digit of the account code. If the account code is 6 digits long, program all 6 segments.
LOCATION 90 - PARTITION 2 FEATURE AND REPORTING SELECTIONS (5 segments, feature
selection data)
Location 90 is used to enable certain features that the user can access or see from the keypad of the
system. In addition, certain communicator reports are enabled in this location. Each of these features
can be enabled by partition. This location contains 5 segments, with eight possible features per
segment. Refer to location 23 for the feature selections. If all the segments are blank (nothing
enabled), the features for partition 1 will be used.
LOCATION 91 - PARTITION 2 ENTRY EXIT TIMERS (6 segments, numerical data)
Location 91 is used to enter the entry and exit times, in seconds. There are 2 separate entry and exit
times. Valid entries are 10-255 seconds. If all the segments are "0", the entry and exit times for
partition 1 will be used.
Segment 1 Entry time 1
Segment 2
Exit time 1
Segment 3
Entry time 2
Segment 4 Exit time 2
Segment 5
Reserved
Segment 6
Reserved
LOCATION 92 - ACCOUNT CODE FOR PARTITION 3 (6 segments, numerical data)
The account code that is sent when reporting partition 3 is programmed in location 92. If location 92
is left unprogrammed (all "10"), then the account code corresponding to the phone number that is
dialled will be used. If the account code is less than six digits, program a "10" in the segment
immediately after the last digit of the account code. If the account code is 6 digits long, program all 6
segments.
Entry time that will be used when a delay 1 zone type
initiates an entry delay
Exit time that will be used for all zones designated as delay 1
Entry time that will be used when a delay 2 zone type
initiates an entry delay
Exit time that will be used for all zones designated as delay 2
NetworX Version 3 Installation Manual
123