GE NetworX V3 Installation Manual page 218

218
NetworX Version 3 Installation Manual
Term
Connection Fault
Connection Type
Contact ID
Control Panel
Timeout
CSD
Current Operator
D
Destination
DHCP Assigned IP
Address
DL900
Download
Download Starting
Downloading
E
Event
Event log
Events
Expander Trouble
and Restores
F
Fail to Communicate
FTC Report Attempts
G
Definition
An Options menu entry that groups connection fault options. A connection fault occurs when the
module cannot log into the GSM network.
An Up/Download menu entry that selects a CSD or GPRS connection.
A Reporting menu entry that selects the Contact ID protocol.
A Reporting setting that configures the maximum time during which the control panel must report an
event. If the NX-7002 report control is configured for secondary reporting and the control panel does
not report the event during this time, the report control reports the event.
This can be from 1 to 255 seconds. If set to 0, the setting is disabled.
Circuit Switched Data. This is a communication format used to upload/download data. It is similar to
a modem but it is wireless and built in to the NX-7002.
An Options menu entry that groups CSD connection options.
An Options setting that displays the name of the automatically or manually selected GSM network
operator. This setting is valid only when the NX-7002 is logged into the GSM network.
A Reporting setting that configures the report destination for the selected report control.
An Options setting that displays the IP address that is assigned to the NX-7002 when it logs into the
GPRS network.
A PC upload/download program for NetworX systems.
The process of sending programming information or data on the panel to a PC running
upload/download software or to the central station.
An Options setting that indicates that downloading is about to start.
An Options setting option that indicates that downloading is taking place.
An alarm condition that has been detected by the control panel.
A list of events that occur in the system regardless of the armed state of the system. They are held in
a sequential event buffer with a time and date stamp. When the log is full, it overwrites the oldest
entries with new data. These events can later be viewed through downloading.
A Reporting menu entry that contains all configurable events for each report control. All events for
report control 1 are enabled by default. Events for all other report controls are disabled by default.
Enabled events are formatted into one or more messages according to pre-configured settings and
sent to the selected report destination.
You must enable Test Reports if using the NX-7002 as backup to another auxiliary dialer.
A Reporting setting that sends an expander trouble and restore report to the selected report control.
A Reporting setting that reports a fail to communicate event to the selected report control.
A Reporting setting that configures the number of attempts that can be made to a specific report
destination before the Fail to Communicate condition is set. This can be from 1 to 15.