Report Methods; Report Controllers; Primary And Secondary Reporting - GE NetworX V3 Installation Manual

Report methods

SMS
You can send reports by SMS in SIA, XSIA, and Contact ID report formats. You can configure one
event list for each report destination.
TCP/IP
You can send reports by TCP/IP in SIA, XSIA, and Contact ID report formats. You can configure
one event list for each report destination

Report controllers

The GSM/GPRS module contains six report controllers. You can configure the events to be reported
and specify two reporting destinations for each report controller. Two of these can be SMS, two can
be TCP/IP. The backup destination, which is used if there is a reporting device problem, should be
another reporting device, for example PSTN.
Setting up the report controllers
Each of the report controllers can be set up separately.
•
Navigate with the
n and press OK to select the report control you want to work on.
•
Navigate with the
Reporting>Report Format and press OK to select the report format.
•
Navigate with the
up SMS.
Note: All events for Report 1 are enabled by default.

Primary and secondary reporting

Reporting for each report controller is done from the GSM/GPRS module or via another reporting
device.
Primary Reporting
If the GSM/GPRS module is used for primary reporting, it acts as the main reporting device for the
security system. You should:
•
Navigate with the
n>Destination and press OK.
•
Enable the autotest report on the panel phone events and panel system events.
•
Ensure the reporting format on the reporting device is the same as that set on the
GSM/GPRS reporting device.
keys to NX-7002 Module>Reporting>Report Control >Report
keys to NX-7002 Module>Reporting>TCP/IP
keys to NX-7002 Module>Reporting >SMS Reporting to set
keys to NX-7002 Module>Reporting>Report Control>Report
NetworX Version 3 Installation Manual
199