Chapter A3
Installing the NetworX V3
CAUTION: Before installing the panel:
Polycarbonate housings
Small polycarbonate housing is adequate for systems with a just a single additional module installed
(usually the TCP/IP module).
Figure 5. Small polycarbonate housing
Installing a basic system
•
Ensure that the unit is mounted on a flat, solid, vertical surface so that the base
will not flex or warp when the mounting screws/bolts are tightened.
•
Leave a 50 mm clearance between equipment enclosures mounted side by side
and 25 mm between the enclosure and the cable pathway.
•
The battery mounting facility inside the housing is only useful for steady state
use of the control panel. Remove the battery for transport of the control panel.
•
Take care that wire terminals are isolated. Use tie wraps to prevent contact with
any other wires or circuits in case wires break.
1
NetworX Version 3 Installation Manual
1
1
27