Sms Contact Id Reporting - GE NetworX V3 Installation Manual

212
NetworX Version 3 Installation Manual
Reporting with partition modifiers
Partition modifiers are used to identify partitions. Events with partition modifiers are sent using the
syntax:
•
See Table 30 for a detailed syntax description.
The settings and events in Table 31 are transmitted in the following message.
•

SMS Contact ID reporting

Each SMS message contains only one event. The information in the message is the same as a Contact
ID message sent over the PSTN with the digits coded using ASCII instead of DTMF.
The following syntax is used
•
Table 32. Contact ID reporting syntax
Format key
aaaa
18
q
nnn
gg
ppp
0
Example
The following example shows Partition 3 account code E9D3 has a keypad tamper (Contact ID 137)
on zone 30 partition 3.
•
Table 33. Contact ID example
Part of Message
E9D3
18
>aaaaaa eennn[/Rin] [eennn[/Rin] ...].
> 987654 BA001/Ri1 BA003/Ri1 YT000 TA030/Ri3.
aaaa18qnnnggppp
Description
Account number for the event that follows. Hexadecimal digits A - F are in upper case
Shows that this is a Contact ID message.
Contact ID qualifier. '1' = activation, '3' = restore.
Three-digit Contact ID event number (decimal).
Two-digit group number (decimal). This contains the partition that generated the event, or zero
for a non-partition event
Three-digit point number (decimal). This contains the zone, user or module number for the event.
Contact ID checksum. This '0' can be ignored.
E9D318113703030
Format key
aaaaa
18
Description
Account number E9D3
Shows that this is a Contact ID message.