Report type
HomeText Control
When HomeText control is
enabled, you can control your
alarm system by sending SMS
text messages from your
mobile phone.
Note:
Set up phone 1 and
then use the SMS
commands to register
more phones
Information
Menu Option
required
language
n>Language
HomeText Report
Select NX-7002 Module>Reporting>HomeText>Users>HomeText User
groups
n>Report Groups
Send
Select NX-7002 Module>Options>HomeText>Relay Unrecognised SMS
unrecognised text
to Admin.
messages to the
Note:
administrator.
User code
User Menu>Users>User n>User Code
Note: In order to be recognized by the system, every HomeText user
must have a valid user code configured in the control panel, otherwise
the system will not accept a command. Any attempt to register, or set
up, a HomeText user without assigned user code will cause sending
the "Unauthorised, access denied" SMS message by the system.
User number
NX-7002 Module>Reporting>HomeText>Users>HomeText User
n>System Control>User Number
Enable HomeText
Select NX-7002 Module>Options>HomeText>System Control>Home
Control
Text Control>Enable.
Select NX-7002 Module>Reporting>HomeText>Users>HomeText User
Set up the user
n>System Control>Password
password
The user must
Select NX-7002 Module>Options>HomeText>System Control>Password
enter a password
Always Required>Enable.
before sending a
HomeText
command
Commands are
Select NX-7002 Module>Options>HomeText>System Control>Only
accepted only
Registered Phones>Enable.
from HomeText
phone numbers.
Select NX-7002 Module>Reporting>HomeText>Registered Phone
Allow the user to
Access>Users n
send HomeText
commands from
Note: Only users included on this list are granted rights to send
a registered
HomeText commands to the system. Removing a user from this list
phone only.
suspends all user's rights to send HomeText commands, including Any
Phone Access privileges.
NetworX Version 3 Installation Manual
Phone 1 is the administrator phone.
205