Using The Gsm/Gprs Module; Obtaining The Gsm/Gprs Module Status - GE NetworX V3 Installation Manual

Report type
Voice channel

Using the GSM/GPRS module

This section provides information on using the GSM/GPRS GPRS module.

Obtaining the GSM/GPRS module status

System status information is GSM/GPRS specific.
Enter programming mode.
1.
Navigate with the keys to NX-7002 Module>Options>Status Check and press OK.
2.
Scroll through the status messages to view the current status of the module. Table 26,
3.
Status messages explains each status message.
Table 26. Status messages
Message
GSM Connection GSM Engine Comms
SIM PIN Accepted
Logged into GSM Network
SIM PUK Required
Information
Menu Option
required
U/D Port Select NX-7002 Module>Options>Network>Port Numbers>U/D Port.
Connection Type Select NX-7002 Module>Up/Download>Connection Type>TCP/IP.
Phone Number Select Installer Menu>Control Panel>System Settings>Feature
Select>Miscellaneous> Use GSM If Line Trouble
Note:
Protocol Select Installer Menu>Control Panel>Communication>Central
Station>Phone Numbers>Phone Number n>Protocol.
Note:
Backup Select Installer Menu>Control Panel>Communication>Phone Number
>Phone Number n>Events>Communications>Test Reports.
Note:
Description
The modem is responding to AT commands.
The SIM is valid and programmed correctly.
The SIM has been enrolled on the GSM network.
The SIM PIN code is blocked. Put the SIM into a mobile phone and enter
the PUK code to unblock it.
NetworX Version 3 Installation Manual
This can only be used when the phone line monitor is
enabled on the panel.
If you want to use the Voice over GSM as the primary means
of reporting, program a '10' in front of the phone number.
Use the latest panel software. All programming is done via
the panel.
Use any of the panel protocols (SIA, ContactID).
Use GSM reporting as backup.
207