GE NetworX V3 Installation Manual page 31

Figure 10. Wired keypad connector block.
At the panel side, run the NetworX bus wires through the ferrite (see Figure 11,
4.
1
position
contacts (see Figure 1, position
Figure 11, position
Figure 11. Panel connector block and the ferrite.
Carefully close the keypad and tighten the 2 screws at the bottom side.
5.
Note: Any opening of the keypad enclosure will cause tamper alarm in the system.
Power up the panel. Select a language from the list with the
6.
Select default settings from the Load Country Defaults list with the
7.
OK.
At the Partition Number prompt, type the partition number and press OK.
8.
At the Keypad Number prompt, type the keypad number and press OK.
9.
), making one loop, and connect the wires to the standard NetworX bus
4
2
).
NetworX Version 3 Installation Manual
). Additionally, connect the shielding to COM (see
2
1
keys and press OK.
keys and press
31