Special Formats - GE NetworX V3 Installation Manual

100
NetworX Version 3 Installation Manual
at the factory default of "0". If you want dual or split reporting, and the split is based on partition,
then location 16 should be programmed to "0" and location 17 should be used to select those
partitions that are to be reported to phone N°3. If no events are to be reported to phone N°3, both
locations should be at "0".
LOCATION 16 - EVENTS REPORTED TO PHONE N° 3 (2 segments, feature selection data)
Segment 1 1 =
2 =
3 =
4 =
5 =
6 =
7 =
8 =
Segment 2 1 =
2 =
3 =
4 =
5 =
6 =
7 =
8 =
LOCATION 17 - PARTITIONS REPORTED TO PHONE N°3 (1 segment, feature selection data)
Location 17 is used when the events to be reported to a phone number are based on the partition,
regardless of the event. If this location is used, location 16 should be "0".
Segment 1
1 =
2 =
3 =
4 =

Special formats

LOCATION 18 - CUSTOM COMMUNICATOR FORMAT (see locations 2, 8, and 14)
Segment 1 1 =
2 =
3 =
4 =
5 =
6 =
7 =
8 =
Alarms
Opening and closings
Zone bypass and bypass restores
Zone trouble and trouble restores
Power fail (AC failure), low battery, power restore (AC restore), and low
battery restore
Bell cut, bell cut restore, telephone line restore
Test reports
Start and end programming, download complete and log full
Zone and box tamper
Auxiliary power overcurrent, and restore
Wireless sensor missing and restore
Wireless sensor low battery and restore
Expander trouble and restore (keypads are considered as expanders)
Fail to communicate
Alarm restore
Tamper restore
Partition 1
Partition 2
Partition 3
Partition 4
On for 1800hz transmit; Off for 1900hz
On for 2300hz handshake; Off for 1400hz
On for checksum parity; Off for double round parity
On for 2 digit event code; Off for 1 digit event code
On for extended reporting; Off for non-extended reporting
Reserved
On for 20 PPS; Off for 10 or 40 PPS
On for 10 PPS; Off for 20 or 40 PPS