Download Parameters - GE NetworX V3 Installation Manual

Segment 2
1 = On for pager format (no handshake required).
2 = On for 1400/2300 handshake
3 = Reserved
4 = Reserved
5 = On for Contact ID
6 = On for SIA
7 = On for 3 digit event code
8 = On for DTMF
Segment 3 Reserved
Segment 4
Inter-digit time for pulse format:
The inter-digit time is the value programmed on this location, divided by the pulse-
rate (PPS) of the programmed format. This is programmed in a binary way: in order to
program the value "10", options 2 and 4 must be selected, for value "5", options 1
and 3 must be selected.
Ex: when the value 10 is programmed on segment 4 and a pulse format of 20 PPS is
used, the inter-digit time is 10/20 = 0.5 sec.

Download parameters

LOCATION 19 - DOWNLOAD ACCESS CODE (8 segments, numerical data)
Location 19 contains the eight-digit access code that the NetworX V3 must receive from the
downloading software before the panel will allow downloading. The factory default code is
84800000.
LOCATION 20 - NUMBER OF RINGS TO ANSWER (1 segment, numerical data)
Location 20 contains the number of rings to answer for a download. Enter a number from "0"
(disabled) to "15". Factory default is "8", so the NetworX V3 will answer after 8 rings.
LOCATION 21 - DOWNLOAD CONTROL (1 segment, feature selection data)
Location 21 contains the feature selections to control download sessions. The following features can
be enabled or disabled using this location (see the feature definitions on pages 5-11).
Segment 1
1 = On: enables two call answering machine defeat
2 = Reserved
3 = On: requires call-back before download session
4 = Shutdown (can only be viewed from the keypad; must be changed by
downloading)
5 = On: locks all local programming. (can only be viewed from the keypad; must
be changed by downloading)
6 = On: locks programming of all locations associated with the communicator
(can only be viewed from the keypad; must be changed by downloading)
NetworX Version 3 Installation Manual
101