GE NetworX V3 Installation Manual page 266

266
NetworX Version 3 Installation Manual
Message Definition
CleanMe A specific smoke
detector (for example,
DP721) is dirty. The
panel detects a degree
of pollution in the
chamber of the
fire/smoke detectors.
Open There is a problem
with the wiring.
Lost The system has not
received RF sensor
transmissions for a
long period of time.
Depending on how the
system is
programmed, this
condition activates a
service report. In
addition, it may
activate a tamper
alarm if armed.
Low Battery An RF sensor battery is
low.
Short Loss The system has not
received RF sensor
transmissions for a
short period of time.
This condition prevents
arming.
Action
Clean the detection chamber of the smoke
detector.
Note: This message is not shown on the LCD
display, only listed in the event log.
Check the zone and zone sensors for damage and
repair any faults.
Note: This message is displayed in case of wired
zones only.
Ensure that the wireless zone module is receiving
power and has not been tampered with. Repair
any faults.
Replace the battery.
Ensure that the wireless zone module is receiving
power and has not been tampered with. Repair
any faults.