Learning-In Additional Wireless Keypads - GE NetworX V3 Installation Manual

174
NetworX Version 3 Installation Manual
Transmitter
Fire detector
Two Button Panic
Four Button Keyfob
Press ## (or press NO repeatedly) to leave the programming mode. The OK to Exit
10.
prompt is displayed. Press OK. The system now functions as a normal alarm system.
Note: You can use the Del. RF Device menu option. to delete an enrolled RF zone (sensor).
Note: It is recommended to first learn-in a detector and then to set up detector's parameters, especially the zone type.
Note: Partition number stored with the alarm event is the first partition the triggered sensor belongs to. So if the
sensor belongs to partitions 1 and 4, the partition number sent with the event will be 1. It should be taken
into consideration when setting up multi-partition sensors or configuring outputs based on alarm events.
Also, in case of tamper on the zone assigned to all partitions, "Siren On" flag is activated only for Partition 1,
so alarm icon is activated only on keypads with assigned Partition 1 (partition 1 keypads and master
keypads).

Learning-in additional wireless keypads

Wireless keypads are a separate type of wireless devices that require different programming
procedures. The procedure below allows to program additional keypads in the system. For step-by-
step instructions about installing the very first wireless keypad, see the Wireless keypad learning-in
procedure section.
Using the existing keypad, enter the programming mode, navigate with the
1.
RF Receivers and press OK.
Note: It is recommended to not learn any devices from a keypad which belongs to a partition different then Partition 1.
Select the relevant module bus ID and press OK. For example, you can select RF
2.
Receiver 32, which is the NetworX V3 built-in receiver.
Select Learn RF Device>Learn RF Keypad, and then select the new keypad number (RF
3.
Keypad 1 to 4) and press OK. The panel starts the learning-in procedure, and the Learn-in
Mode message is displayed.
Action
Press and hold the test button.
Note: Some fire detectors require activating the tamper switch instead.
See the detector manual for exact instructions.
Note: If installer wants to replace a fire sensor (the zone type is set to Fire)
then the installer at the beginning should change the zone type to the
other type, delete the sensor, learn-in and mount a new sensor, and then
set up back the Fire zone type.
Press and hold the two buttons together.
This keyfob needs a special procedure to start the learn-in mode. See the
keyfob manual for precise instructions.
Note: If the key sequence, that is required to start the learn-in mode on
the keyfob, is accidentally triggered by the user, the keyfob creates a new
encryption key. It stops all communication between the keyfob and the
radio module. In order to fix it, the installer needs to delete the keyfob
using the RF Receivers menu, and then to learn-in the keyfob again.
keys to