GE NetworX V3 Installation Manual page 217

Term Definition
Account Code A Reporting setting that configures the SIA or Contact ID account number for the selected report
receiver. SIA account numbers are 6 digits long. Contact ID account numbers are 4 digits long. The
letters A, B, C, D, E and F can be included in account codes.
Alarm Restores A Reporting setting that sends a report to the selected report control when the alarm has been
restored after an alarm.
Alarms A Reporting setting that sends a report to the selected report control when an alarm occurs.
A Control Panel menu entry that cancels all pending reports if the system is disarmed during
All abort
reporting.
Allow Calls From An Up/download setting that answers calls from a known phone number only. To enable this setting,
you must enable Remote Initiated and program the phone number of the PC in Up/Download>Phone
Number.
Any Phone Access A Reporting menu entry that lists all the users with rights to send HomeText commands from the
phone unknown to the system.
Note: Sending a HomeText message from the unknown phone requires adding the phone number
registered for the user and the user password at the beginning of the command. They are used by
the system to confirm the user's identity. For example, type 32444123456 44aa44 status to send a
status command, where 32444123456 is your telephone number registered in the system, and
44aa44 is your password.
Application An Options menu entry that groups application related status messages.
Arm/Disarm/Alarm A Reporting menu entry that groups the events that are reported to the selected report control.
Auto U/D at Test An Up/download setting that configures the NX-7002 to automatically dial the PC to initiate an
Time upload/download session after an autotest. You must program the autotest on the control panel.
An Up/download setting that configures the NX-7002 to automatically answer any incoming calls. To
Auto-answer
enable this setting, you must enable Remote Initiated.
Aux Short Circuit and A Reporting setting that sends a report to the selected report control when too much current is
Restores detected. A restore report is also sent when the overcurrent condition is fixed.
B
Backup Destination A Reporting setting that configures the backup destination for the selected report control. If using
another device as the backup destination, set the reporting format in Reporting>Backup Format and
enable test report events in the backup device.
Backup Format A Reporting setting that configures the reporting format when using another device as backup. You
must set the same reporting format on the backup device.
Battery Fault An Options setting that indicates that there is a problem with the battery.
Bit Error Rate An Options setting that displays the current Bit Error Rate (BER). The BER value is periodically updated
when the NX-7002 is logged into the network. This information is used for verification purposes only.
BER values range from 0% to 7%, with 99 as unknown. It is applicable to GPRS only.
Bus Power Fault An Options setting that indicates that there is a problem with power to the bus.
C
Callback Required An Up/download setting that configures the NX-7002 to call back the PC in order to initiate an
upload/download session. To enable this setting, you must enable Remote Initiated.
CID Contact ID reporting protocol
A Reporting menu entry that groups together the communication events that are reported to the
Communications
selected report control.
NetworX Version 3 Installation Manual
217