Event Log Events - GE NetworX V3 Installation Manual

238
NetworX Version 3 Installation Manual
Table 36. Event description
Event description
L1
L2
Event Type
PN
Partition Name
Zone/User Name
UN/ZN
HH:MM
DD/MM
LOG

Event log events

Table 37. Event list
Event message
10 unsuccessful
download attempts
Alarm
Alarm Restore
Autotest
Aux Com Fail
Aux Com Fail Restore See Aux Com Fail event message.
Box Tamper
Burglary
Burglary Restore
Bus Fault
Bus Fault Restore
Explanation
Event Type PN Partition Name
HH:MM DD/MM UN/ZN Zone/User Name LOG
The type of event that occurred.
The number of the partition in which the event occurred.
The name of the partition in which the event occurred.
The zone name or user name.
The user number, zone number or device number.
The hour and the minute the event occurred.
The day and month the event occurred.
The position of the event in the event log.
Explanation
This is a security feature. This event occurs if someone tries to hack into the system.
An alarm has been tripped.
See Alarm event message.
An autotest message was sent to the central station.
Failure to communicate with the external module, for example, the TCP/IP module.
A box tamper.
A burglary zone has been tripped.
See Burglary event message.
Panel detects when bus is shorted to ground, forced to High level or there is a problem
with receiving valid bytes. About 8 seconds after this problem is detected this event will
be logged and the external bus will get disconnected for about 5 minutes. If this
situation does not disappear after 5 minutes then the external bus will be disabled for
another 5 minutes. Entering installer code will log Bus Fault Restore event and enable
the bus again.
See Bus Fault event message.