GE NetworX V3 Installation Manual page 201

Note: You can also program this by entering 'G' at the start of the phone number to use the GSM instead of the
PSTN. Press #0 to enter 'G' on the keypad.
If you are programming the system using the DL900 software, enter 'A' at the start of the telephone number.
Control panel/ GSM/GPRS module as backup for the GSM/GPRS module
Backup reports are sent when the GSM/GPRS module fails to send primary reports. Backup reports
can be sent by another report control on the module or by another device on the system.
Other report control of the GSM/GPRS module as backup
•
Set a report control to Report When>Report Always.
•
Program the first and backup report destinations to one of the TCP/IP or SMS
destinations or set another report control as the report control backup destination.
Control panel as backup
When the GSM/GPRS module fails to report, it sends an expansion event which the control panel or
auxiliary dialer reports.
•
Select NX-7002 Module>Reporting>Report Control>Report 1>Backup
Destination>Other Dialer
•
Set a report control to Report When>Report Always on the panel.
•
Enable the autotest report on the panel phone events and panel system events.
•
Ensure the reporting format on the dialer is the same as that set in NX-7002
Module>Reporting>Backup Format.
GSM CSD connection (upload/download call back from audio)
GSM CSD connection is a feature that lets you upload/download without having to pay the extra cost
of a CSD telephone number/service. Instead, you call in on the audio telephone number to begin an
upload/download session.
Note: Use the DL900 version that supports GSM downloading.
To begin an upload/download session with the call back from audio feature enabled:
Select NX-7002 Module>Up/Download>U/D Call Back after Voice Call>Yes and press
1.
OK.
Call the GSM/GPRS module analog telephone number.
2.
Between two and ten seconds cancel the call.
3.
GSM/GPRS module waits for ten seconds and then starts an upload/download session.
4.
To begin an upload/download session with the call back from audio feature enabled and using the
NX-534E in combination with GSM/GPRS module:
Call the GSM/GPRS module analog telephone number.
1.
GSM/GPRS module answers the call for the control panel and then hangs up.
2.
NetworX Version 3 Installation Manual
201