GE NetworX V3 Installation Manual page 23

8
Battery low
9
Alarm
10
11
!
Trouble
12
Service
13
Ready to arm
Note: In case of power supply problems, the following icons are displayed:
Power
ON
NO faults
ON
AC fault
Battery OK
Blinking
AC OK
Battery fault
This icon is only available on the wireless keypad and flashing when the
keypad battery is low.
This icon flashes in case of an alarm condition.
This icon is only available on the wireless keypad and indicates RF-link
field strength. The one most to the left indicates absence of RF, the one
most to the right indicates full signal strength. It will flash as long as the
keypad is not registered yet.
This icon indicates a system trouble condition, for example, fire trouble,
day zone trouble or AC power loss. You can display the trouble list by
pressing the # (hash) button on the keypad (see Appendix 4: Service
messages on page 264.)
This icon is ON in case the system needs to be serviced. It can indicate
many conditions, for example, ground fault, phone fault, fail to
communicate, box tamper, loss of system time, and similar problems. You
can display the service message list by pressing the # (hash) button on the
keypad (see Appendix 4: Service messages on page 264.)
If the system is OK to arm, the V-sign icon is displayed. If it is NOT OK to
arm, the V-sign disappears. In case a force armable zone is open, it will
show a flashing V-sign (see Table 15 Default zone types, and Force
Armable menu option description in the glossary.)
Normal Screensaver
mode
ON
Blinking
ON
Blinking
ON
NetworX Version 3 Installation Manual
mode
23