Powering Up The System; Entering Programming Mode; Changing The User Interface Language - GE NetworX V3 Installation Manual

40
NetworX Version 3 Installation Manual
Note: Press NO key to clear any incorrectly entered user code or other information.

Powering up the system

When the NetworX V3 is powered up for the first time, the keypad language, keypad defaults,
partition and keypad number must be set. These options must also be set each time a keypad is
defaulted.
The Set KP Language option sets the first language of the keypad.
5.
The Load Country Defaults option sets the country specific keypad defaults. It does not
6.
default the keypad.
The Partition Number and Keypad Number options set the keypad address.
7.
Use the navigation keys to scroll between the different options and press OK to select an option. See
Navigating the menus for more information.
Prior to installing a wireless keypad into the system, the keypad should first be "learned-in" by the
panel in order to guarantee mutual recognition. See the Wireless keypad learning-in procedure
section for step-by-step instructions.

Entering programming mode

Your installer code allows you to program the system through the installer menu. There are two
levels in the installer menu. The light menu contains the most important options and the advanced
menu contains additional options. The system cannot be armed while in programming mode on the
current keypad or another keypad.
Press OK at the system prompt and enter your installer code. For a list of default codes,
1.
see the Country codes section.
Use the
2.
Structure included in your language kit. The light menu is in green text and the advanced
menu is in black text.
Select OK to select an option or use the numerical/character keys to edit the existing
3.
option.
Note: The light installer menu is displayed by default. To switch to advanced menu, navigate to Installer
Menu>Maintenance Mode>Advanced and select Enabled. The keypad displays the advanced menu until this
option is disabled.

Changing the user interface language

Press OK at the system prompt.
1.
Press OK again to display the system prompt in a different language.
2.
Press OK until you find the language you require.
3.
Continue using the keypad as normal.
4.
Note: When the NetworX V3 is powered up for the first time, only the single language selected during keypad
installation is available. To toggle the user interface language, the available languages must be defined first
(Installer Menu>This Keypad>Set KP Language>Language 1 to 4.)
keys to navigate the menu. The full menu map can be found in the Menu