GE NetworX V3 Installation Manual page 240

240
NetworX Version 3 Installation Manual
Event message
Fire
Fire Restore
First Open
Forced Door
Forced Door Restore
Ground Fault
Ground Fault
Restore
Keypad Tamper
Last Close
Late Close
Line Fault
Line Fault Restore
Listen-in
Log Full
Low Batt Restore
Low Battery
Mains Fail Restore
Mains Failure
Manual Fire
Manual Test
Medical (Aux2)
Off-normal Autotest
Open (disarm)
Output Restore
Output Trip
Over-current
Over-current
Restore
PA Panic Alarm
Panic Keypad
Explanation
A fire alarm has been tripped.
See Fire event message.
The time at which the first partition was opened.
The door was opened without an authorisation from the system.
See Forced Door event message.
Grounding problem occured.
See Ground Fault event message.
A keypad tamper.
The time at which the last partition was closed.
A user disarmed the system after the closing time specified in the panel schedules.
Telephone line faults.
See Telephone Fault event message.
The start of a listen-in session.
The event log is full and the events must be reported to the up/download software. An
event can also be sent to the central station.
See Low Battery event message.
The standby battery for the control panel/expansion module is low.
See Mains Failure event message.
The 220 V has disappeared.
A manual fire alarm generated by pressing the keys 1 and 3 on the keypad.
A manual test call to the central station.
A medical alarm generated by pressing the keys 4 and 6 on the keypad.
Off normal automatic test result.
Opening (disarm) by a specific user.
See Output event message.
An output has been activated.
An excessive amount of current has been drawn from one of the outputs.
See Over-current event message.
A personal attack alarm has been tripped.
A panic alarm generated by pressing the function key on the keypad.