Test The Netgear Prosafe Vpn Client Vpn Tunnel Connection - NETGEAR FVS336Gv3 Reference Manual

ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv3

Test the NETGEAR ProSAFE VPN Client VPN Tunnel Connection

Note: In this section, the NETGEAR ProSAFE VPN Client is referred to as
the VPN client.
After you configure the IPSec VPN connection on the VPN firewall and the VPN client, you
can test the VPN tunnel connection.
The following procedure assumes that you use the default authentication phase name
Gateway and the default IPSec configuration name Tunnel.
If you configured the connection manually and changed the names, use vpn_client (or any
other name that you configured) as the authentication phase name and netgear_platform (or
any other name that you configured) as the IPSec configuration name.

To initiate a VPN tunnel connection on the VPN client:
On the computer that has the VPN client installed, right-click the system tray icon, and select
Open tunnel 'Tunnel'.
When the tunnel opens successfully, the Tunnel opened message displays above the system
tray.
After the VPN client is launched, it displays an icon in the system tray that indicates whether
a tunnel is opened, using a color code.
Set Up Virtual Private Networking With IPSec Connections
364