Manage Tunneling For Ipv6 Traffic; Manage 6To4 Automatic Tunneling - NETGEAR FVS336Gv3 Reference Manual

ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv3
The Connection Status screen shows a valid IP address and gateway. You are
connected to the Internet. For more information about the connection status, see
View the WAN Port Status and Terminate or Establish the Internet Connection
page 598.
Note: If the configuration was not successful, see
Connection

Manage Tunneling for IPv6 Traffic

The following sections provide information about managing tunneling for IPv6 traffic:
•

Manage 6to4 Automatic Tunneling

• Manage ISATAP Automatic Tunneling
• View the Tunnel Status and Tunnel IPv6 Addresses
Manage 6to4 Automatic Tunneling
If your network is an isolated IPv6 network that is not connected to an IPv6 ISP, you must
make sure that the IPv6 packets can travel over the IPv4 Internet backbone by enabling
automatic 6to4 tunneling.
The following sections provide information about managing 6to4 automatic tunneling:
• 6to4 Tunnel
• Enable 6to4 Automatic Tunneling
6to4 Tunnel
If your network is an isolated IPv6 network that is not connected to an IPv6 ISP, you must
make sure that the IPv6 packets can travel over the IPv4 Internet backbone by enabling
automatic 6to4 tunneling.
on page 619.
Configure the IPv6 Internet and WAN Settings
101
Troubleshoot the ISP
on