NETGEAR FVS336Gv3 Reference Manual page 440

ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv3
Setting
Secondary DNS Server
Client Address Range Begin The first IP address of the IP address range that you want to assign to the
Client Address Range End
Add Routes for VPN Tunnel Clients
Destination Network
Subnet Mask
Note: For more information about client IP address ranges and route
settings, see
14. Click the Next button.
The SSL VPN Wizard Step 5 of 6 screen displays. If you did not select the Port
Forwarding check box on the SSL VPN Wizard Step 1 of 6 screen in
the SSL VPN Wizard Step 5 of 6 screen are masked out because they do not apply to a
VPN tunnel portal.
15. Enter the settings as described in the following table.
Set Up Virtual Private Networking with SSL Connections
Description
The IP address of the secondary DNS server that is assigned to the VPN
tunnel clients. This setting is optional.
VPN tunnel clients.
The last IP address of the IP address range that you want to assign to the
VPN tunnel clients.
Leave this field blank or specify a destination network IP address of a local
network or subnet that is not used. This setting applies only when full-tunnel
support is disabled.
Leave this field blank or specify the address of the appropriate subnet mask.
This setting applies only when full-tunnel support is disabled.
Configure the SSL VPN Client
440
on page 462.
Step 7, the fields on