NETGEAR FVS336Gv3 Reference Manual page 464

ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv3
7. In the Client IP Address Range section, enter the settings as described in the following table.
Setting
Enable Full Tunnel Support
DNS Suffix
Primary DNS Server
Secondary DNS Server
Client Address Range Begin The first IP address of the IPv4 address range that you want to assign to the
Client Address Range End
8. Click the Apply button.
Set Up Virtual Private Networking with SSL Connections
Description
Select this check box to enable full-tunnel support. Full tunnel support
provides clients access to the entire LAN network.
If you leave this check box cleared (which is the default setting), full-tunnel
support is disabled but split-tunnel support is enabled. You must add one or
more IPv4 client routes to provide clients access to specific networks (see
Add an IPv4 Route for VPN Tunnel Clients
Note: When full-tunnel support is enabled, client routes are not operable.
A DNS suffix to be appended to incomplete DNS search strings. This setting
is optional.
The IP address of the primary DNS server that is assigned to the VPN tunnel
clients. This setting is optional.
Note: If you do not assign a DNS server, the DNS settings remain unchanged
in the SSL VPN client after a VPN tunnel is established.
The IP address of the secondary DNS server that is assigned to the VPN
tunnel clients. This setting is optional.
VPN tunnel clients. By default, the first IPv4 address is 192.168.251.1.
The last IP address of the IPv4 address range that you want to assign to the
VPN tunnel clients. By default, the last IPv4 address is 192.168.251.254.
464
on page 465).