Manually Configure A Pppoe Ipv4 Internet Connection - NETGEAR FVS336Gv3 Reference Manual

ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv3
The VPN firewall attempts to make a connection according to the settings that you
entered.
16. Verify the connection:
a. Select Network Configuration > WAN Settings > WAN Setup.
The WAN Setup screen displays the IPv4 settings.
b. In the IPv4 WAN Settings table, click the Status button for the WAN interface for
which you want to display the connection status.
The Connection Status pop-up screen displays.
The Connection Status screen shows a valid IP address and gateway. You are
connected to the Internet.
Note: If the configuration was not successful, see
Connection

Manually Configure a PPPoE IPv4 Internet Connection

If you installed login software, your connection type is most likely PPPoE. To configure a
PPPoE IPv4 Internet connection, enter the PPPoE IPv4 information that your IPv4 ISP gave
you. If you do not have this information, contact your IPv4 ISP.
For each WAN interface, you need the following information: login name, login password, and
if applicable, account name and domain name. If your ISP assigns you a static IP address,
you also need the IP address, IP subnet mask, and IP addresses of the primary DNS server
and secondary DNS server.
on page 619.
Configure the IPv4 Internet and WAN Settings
39
Troubleshoot the ISP